In these six videos, I discuss fabricating the fuselage holding fixture used to assist in gluing the fuselage together. I also show how the fuselage rests in the fixture. In video 5, I mistakenly discuss putting the seat back in the wrong way (based on the kit with pre-drilled holes). In the last video, I address my mistake. The pre-drilled hole is for the bell crank support. (With the kit, this can sometimes be confusing because there are times the fuselage is upside down and therefore everything you’re working on is reversed.) However, while not mentioned in the video, I noticed that only one fuselage side had a pre-drilled hole, just aft of the seat which was also for the bell crank support. Therefore, if it isn’t clear in video six, just know that the hole in the seat should be closest to the fuselage side that also has a pre-drilled hole for the bell crank support.